MEMBRANE:
• Patented Outside/In Polymeric Membrane
Filtration Module that is NSF 61, EPA, ACS
and CDHS certified.
• BioVir certified and tested system for log
reduction of Bacteria and Virus.
• Four bundles of 0.02 micron filtration.
• High performance flow rates, up to 12 gpm.
• Standard 2.5” top inlet opening for connection
with standard backwashable control valves to
in/out heads, for metered service.
• Standard bottom drain and opening for
drainage and cleaning purposes of the system.
• No special controller or programming needed.
• Economical POE packaging that looks like
standard water treatment equipment.
• Low waste water discharge used when cleaning.
• Designed for cyst reduction, turbidity, and
fine sediment filtration applications.
• Protection during power outages and intermitent power.
MEMBRANE:
• Patented Outside/In Polymeric Membrane
Filtration Module that is NSF 61, EPA, ACS
and CDHS certified.
• BioVir certified and tested system for log
reduction of Bacteria and Virus.
• Four bundles of 0.02 micron filtration.
• High performance flow rates, up to 12 gpm.
• Standard 2.5” top inlet opening for connection
with standard backwashable control valves to
in/out heads, for metered service.
• Standard bottom drain and opening for
drainage and cleaning purposes of the system.
• No special controller or programming needed.
• Economical POE packaging that looks like
standard water treatment equipment.
• Low waste water discharge used when cleaning.
• Designed for cyst reduction, turbidity, and
fine sediment filtration applications.
• Protection during power outages and intermitent power.
APPLICATIONS:
• Grey Water and Rainwater use, catchment,
and recycling.
• Tannin removal.
• RO Pre-filter.
• Polishing post filter filtration.
• Colloid removal.
• Bacteria, cyst and virus removal 
• Grey Water and Rainwater use, catchment,
and recycling.
• Tannin removal.
• RO Pre-filter.
• Polishing post filter filtration.
• Colloid removal.
• Bacteria, cyst and virus removal 

TECHNICAL INFORMATION:
• Continuous flow at 10 gpm filtration
at 0.02 microns.
• 4.4 log reduction of Bacteria.
• 2.4 log reduction of Virus.
• 2.0 log (est) reduction of Cyst.
• 100,000 MWC)
FILTRATION LEVEL:
• 0.02 micron.
• Operating Temperature: 35 to 100 degrees F.
• Operation Pressure: 10 to 100 psi.
• Continuous Flow Rate: 10 gpm.
• The system provides a treated flow of up to
12 gpm at 25 C and 60 psi.
• Membrane is NSF 61 Certified.
• Raw Water Specification:
• Pre-filtration: 5 microns or less.
• Chlorine: 1.0 ppm maximum for
continuous flow (up to 2000 ppm
for cleaning only).
• Iron: Less than 0.30 ppm.
• Manganese: Less than 0.05 ppm.
• Silt Density Index: Less than 6.0
• pH: 3 to 11.
• Pressure Decay Test (PDT) is required
upon installation.
TECHNICAL INFORMATION:
• Backflush: Once per day (5 minutes at
0.7 to 2 gpm).
• Drain Flush: Once per week (2 minutes at
5 gpm).